SLO-30VB

Not affected by external light interference, with
built-in micro photoelectric sensor with wire amplifier

◼︎ Variable dimming type unaffected by external light interference

◼︎ Bring in light display light

◼︎ High speed response time: 1ms or 300ms, depending on the specific model

◼︎ Detection distance:0 ... 30 mm

Slot width	30mm×45mm，Beam distance from outer edge 10mm
Voltage and current	10~30VDC, 30mA
Power protection circuit	Protected against reverse polarity and transient voltages
Output circuit structure bipolar	NPN and PNP
Output capacity	Each output is 150mA
Output protection circuit	Prevent erroneous pulses during power on and output short circuits
Output response time	1ms or 300ms, depending on specific model
Repeatability	250ms or 75ms, depending on specific model
Adjustability	Non adjustable
Pilot lamp	Green：Power on/off Yellow：Signal condition indicator light
Material quality	Structure：ABS plastic/polycarbonate cool Lens：Acrylic organic glass
Environmental limitations	IP67 NEMA6
Anti-interference ability	Illumination of the receiving surface: Incandescent lamp below 3000lx Sunlight below 10000 lx
Connect	2 m (6.5')5-conductor PVC-jacketed attached cable.
Working conditions	Temperature：-20~+60℃ Maximum relative humidity：90%，50℃ (without condensation)
Insulation resistance	20MΩ (500VDC megohmmeter) between the overall conductor and the housing
Withstand voltage	AC1000V 50/60Hz 1min between the overall conductor and the housing
Vibration (durable)	Up and down amplitudes of 1.5mm at 10~55Hz for 2h in X, Y, and Z directions